Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch PCM 7 S Manual Original

OBJ_BUCH-1270-001.book Page 31 Thursday, July 22, 2010 12:44 PM
41 Slide device
42 Casing stop for depth stop
43 Screws for insert plate
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.

Technical Data

Sliding Mitre Saw
Article number
Rated power input
No-load speed
Laser type
Laser class
Weight according to
EPTA-Procedure
01/2003
Protection class
Permissible workpiece dimensions (maximal/minimal)
see page 36.
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Mounting hole diameter

Noise/Vibration Information

Measured sound values determined according
to EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 94 dB(A);
Sound power level 107 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Bosch Power Tools
Vibration total values (triax vector sum) deter-
mined according to EN 61029:
Vibration emission value a
tainty K =1.5 m/s
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 61029 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
PCM 7 S
sents the main applications of the tool. However
3 603 M01 3..
if the tool is used for different applications, with
different accessories or poorly maintained, the
W 1200
vibration emission may differ. This may signifi-
-1
min 4800
cantly increase the exposure level over the total
nm 650
working period.
An estimation of the level of exposure to vibra-
mW < 1
tion should also take into account the times
2
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
kg 11.8 tal working period.
Identify additional safety measures to protect
/II
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 2006/42/EC.
mm 190
Technical file at:
mm 1.4–2.5
Robert Bosch GmbH, Dept. PT/ESC,
mm 30
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 22.07.2010
English | 31
2
<2.5 m/s , Uncer-
h
2
.
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 W43 | (22/7/10)