Amprobe AU92 Manual De Uso página 11

Diode Tests (see fig. 6)
1. Set the Function knob to the " Ω
diode test.
2. Connect the red test lead to the "VΩ" jack and the black test lead to the "COM"
jack.
3. Turn off power to the circuit under test. External voltage across the components
causes invalid readings.
4. Touch probes to the diode. A forward-voltage drop is about 0.6V (typical for a sili-
con diode).
5. Reverse probes. If the diode is good, "OL" is displayed. If the diode is shorted,
"0.00" or another number is displayed.
6. If the diode is open, "OL" is displayed in both directions.
7. Audible Indication: Less than 0.25 Ω.
Continuity Measurements (see fig. 7)
1. Set the Function knob to the " Ω
2. Connect the red test lead to the "VΩ" jack and the black test lead to the "COM"
jack.
3. Turn off power to the circuit under test. External Voltage across the components
causes invalid reading.
4. Connect the test leads to the two points at which continuity is to be tested. The
buzzer will sound if the resistance is less than approximately 25Ω.
Frequency and Duty Cycle Measurements (see fig. 8)
1. Set the Function knob to the "Hz" or "%" position.
2. Connect the red test lead to the "VΩ" jack and the black test lead to the "COM"
jack.
3. Connect the test leads to the point of measurement and read the frequency or duty
cycle from the display.
Temperature Measurements (see fig. 9)
1. Set the Function knob to the desired temperature range: °C, °F.
2. Connect the K-type thermocouple to the TEMP adapter and plug into VΩ and COM.
3. Match the polarity of the adapter to the polarity of the thermocouple.
4. Connect the TEMP adapter to the VΩ and COM jacks.
" position. Use the Function button to select
" position. Set Function button to "
9
".