Safety Instructions; Technical Specifications; How To Use - Polaroid Candy Play 3D Pen Guia De Inicio Rapido

Ocultar thumbs Ver también para Candy Play 3D Pen:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
QUICK START GUIDE

Safety Instructions

• WARNING - BURN HAZARD: Parts of this product get very hot during use
(approx. 100°C / 212°F). DO NOT touch the tip of the pen, the surrounding
area (where you see this sign
cause a BURN.
• Before storage always allow the product to completely cool after use.
• This product IS NOT A TOY.
• This product is suitable for ages 14+ unless under adult supervision.
• Please read this Quick Start Guide carefully before use.
• If switched on, always put the pen back in its holder when not drawing.

Technical Specifications

Model No.: 3D-FP-PL-2004-00
Power Requirement: A 5.0 Volt DC, 2 Amp (minimum) power adapter
(5.0VDC
2.0A) MUST be used. IMPORTANT: Using an incorrect power
adapter will result in the Pen not working correctly.
Pen Size: 195 (l) x 37 (w) x 29 (d) mm
7.67 (l) x 1.45 (w) x 1.14 (d) inch
Refills: Polaroid Candy Cartridges (3D-FL-PL-2505-00, 3D-FL-PL-2506-00,
3D-FL-PL-2507-00, 3D-FL-PL-2508-00, 3D-FL-PL-2509-00, 3D-FL-PL-2510-00,
3D-FL-PL-2504-00).
USB Cable: Type-C to USB-A 1.5m / 4.9ft
Guarantee: 12 Month Manufacturer's Guarantee (this may differ by state/
country according to minimum statutory requirements).
Safety: Auto Turn-off after 8 mins, for added safety.
For up-to-date and further information please visit:
www.polaroid3d.com/candypen
6
), or the melted Candy as it could

How To Use

1. Use the USB cable provided to connect to a 5.0 Volt DC, 2 Amp (minimum)
power adapter (5.0VDC
2.0A).
2. Press the Power button (
). The LED Indicator light will show red to
indicate that the Polaroid CandyPlay 3D Pen is heating up.
3. Once the LED Indicator light turns blue, the 3D pen is heated to the correct
temperature and is ready to use.
Inserting a Candy Cartridge
1. Open up the Candy Cartridge Loading Point (
2. Insert the Candy Cartridge into the Loading
Point lengthways. Insert the Candy as a diamond
shape, with a long corner edge placed in first
(see illustration).
3. The Candy Cartridge should easily slot into
the Loading Point. If it does not, do not force it,
remove the Candy Cartridge, ensure you are
inserting it as illustrated and try again.
4. Once the Candy Cartridge has slotted into the
Loading Point, close the cover.
Note: When using the pen for the first time, or after cleaning, two Candy
Cartridges will need to be inserted before any Candy will be extruded.
How to draw
1. Press the Start button (
) and the piston inside the pen will slowly start
to push the Candy Cartridge through the heated nozzle and you will then
see it start to extrude.
2. To stop the Candy extruding, press the Start button (
).
) again.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3d-fp-pl-2004-00

Tabla de contenido