Sky link PS-MT Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
Motion Sensor
Model: PS-MT
Congratulations on your purchase of the Skylink Motion Sensor,
Model: PS-MT. The sensor will monitor any movement around your premises
and works with the SkylinkNet Internet Hub and the Skylink M-Series
Alert/Alarm System.
Section 1 - Insert a battery in the Motion Sensor
NOTE: The battery for the Sensor is not included. Please refer to
instruction below to insert an AA Alkaline Battery.
1. Use a coin to open the Motion Sensor cover.
2. Insert an AA Alkaline Battery.
Safety Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interferences that may cause undesired operation.
WARNING:
Changes or modi cations to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
CE - DECLARATION OF CONFORMITY:
This equipment complies with the requirements relating to electromagnetic
compatibility, EN 301489-1, EN301489-3, EN300220-1, EN300220-2 and
EN60950-1. This equipment conforms to the essential requirement of the
1999/5/EC R&TTE Directive.
Section 2 -
Programming the Sensor with M-Series Main Console
NOTE: You can program in total up to 4 sensors in one zone. If you try to
program the fth sensor, the rst sensor will be removed.
Learn Button
1. Press the learn button on the back 2. Zone 1 is selected. Press the learn
of the M-Series Main Console for button to select the zone you want
3 seconds until the Zone 1 light to program the sensor.
is ashing.
3. Open the Motion Sensor
4. Once the sensor is programmed,
cover with a coin and press the
the Main Console will beep once and
learn button.
the corresponding zone led will be off.
Package Contents
A
Parts
Description
A Motion Sensor
B Mounting Accessories
Section 3 -
Programming the Sensor with SkylinkNet Internet Hub
NOTE: Programming the sensor with the SkylinkNet Internet Hub
must be done from the SkylinkNet App.
Zone LED
1. Go to "More" and tap
on "System Settings".
5. Tap on "Motion
Sensor".
B
Quantity
1
1
2. Tap on "Setup 3. Tap on "Add Device". 4. Tap on "Sensors".
Wizard".
6. Name your Sensor, 7. Tap on "Learn Now"
location and tap and follow the video to
"Continue". activate the sensor.