Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4 - Testing the Sensor with M-Series Alert/Alarm System
1. Slide the switch at the back
2. Move in front of the motion
of the Main Console to
sensor to trigger the sensor. The
Alert Mode.
Led will ash when motion is
detected.
3. The Main Console will start
4. The motion sensor will stop
beeping and ash the Zone
beeping and ashing the LED if there
LED.
is no motion detected for 15 seconds.
Section 7 - Battery Indication/Sensor Failure
M-Series Alert/Alarm System
NOTE: The corresponding zone LED in the Main Console will ash if a sensor
failure or low battery is occurred.
When a sensor failure occurs, try the following:
1. Check if the sensor is located at where it should be.
2. Check if there is any physical damage to the sensor.
3. Move the Main Console closer to the sensor, if the red LED stops ashing,
that means the Main Console or sensor needs to be relocated.
4. Replace the battery of the sensor if the Main Console does not respond
when the sensor is activated within short range.
Section 5 - Testing the Sensor with SkylinkNet Alarm System
1. Activate the sensor by
2. The blue icon will turn red indicating
moving in front of the motion
that the motion is detected.
sensor. The Led will ash
when motion is detected.
4. The red icon will turn back to blue
3. Don't move in front of the
indicating that there is no motion
motion sensor for 15 seconds.
detected.
Troubleshooting M-Series Alert/Alarm System
Problem
Solution
The M-Series Main Console
- You must program the sensor to the control
panel does not respond to
panel before they can work together.
the sensor?
- You must erase all the sensors in that zone
Can I erase just one sensor
and then program the sensor you want to
from a zone in the M-Series
keep.
Main Console?
I have multiple sensors in a
zone and the zone LED keep
ashing indicating a sensor
- You need to test each sensor individually.
failure. How do I know which
sensor is having the
problem?
Section 6 - Installing the Motion Sensor
Place the sensor in the appropriate location:
The motion sensor can be mounted with a double-sided tape or screws
in a corner, straight wall, ceiling or stand freely by itself.
Warranty
ONE YEAR WARRANTY
This product is guaranteed to be free of defects in materials and
workmanship for 1 year from the date of purchase. If this product is
defective, call 1-800-304-1187 for repair or replacement parts.
Guarantee does not include normal wear and tear or batteries.
If you have any questions, problems or missing parts,
please call Skylink Customer Support:
9:00am - 5:00pm EST, Monday-Friday.
1-800-304-1187
Or e-mail us at support@skylinkhome.com
www.skylinkhome.com
CUSTOMER SERVICE
17 Sheard Avenue,
Brampton, Ontario,
Canada L6Y1J3
P/N : 101Y144 Rev:0
©2014 SKYLINK GROUP.
Publicidad
