Ribiland PRJET150L Manual De Instrucciones Y Mantenimiento página 3

CAUTION ! To reduce the risk of fire, electric shock or injury to persons during
the installation and use of your pump, it is recommended that basic safety precautions should always be
taken, including the following precaution:
Read all these instructions before starting to operate this product and keep these instructions in a safe
place.
1) GENERAL
The JET pump has been designed to suck up clear water.
It should be installed in a location that is dry, ventilated and protected from bad weather and heat. The
maximum suction height should not exceed 8 meters.
Correctly installed, your pump will function with maximum, output and should meet your requirements fully:
read the following Instructions carefully.
2) TECHNICAL CHARACTERISTICS
Model ............................: JET150L (JSP1500F)
Type ...............................: Self-priming
Max suction ...................: 8 m
Output Discharge ..........: 65 l/min at 10 m
Motor power ..................: 1500 W
Power supply .................: 230V ~ 50Hz
Speed .............................: 2850 rpm
3) INSTALLATION
a) Important recommendations;
Before connecting to the electrical supply, you must:
 Fix the pump firmly to the ground or onto a suitable support. To do this, there are two notches
provided for this purpose in the foot of the pump for securing it with bolts (not supplied).
 Check that the mains supply corresponds to that given on the pump's technical table.
WARNING
 The warranty does not cover accidents due to poor installation. This pump should be installed
according to the national standards in force (NFC 15100 for France) and by qualified personnel. We
advise you to call in an electrician.
 The fixed pipe works to which the pump will be connected must have a separation device with
contacts of at least 3mm opening distance at all poles.
 If the pump is used for swimming pools it must be powered by a transformer with circuit breaker
(RCCD) with sensitivity not exceeding 30mA. The pump should not be used in outside fountains,
garden ponds and similar places.
N.B.: This pump is not intended for cleaning or other maintenance operations on swimming pools. When it
is used for swimming pools, it must be installed in an enclosed service area.
The total manometric height should not-exceed 35m. The connection cable should be at least of the type
H05RNF –3 x 1 mm (live, neutral and earth).
User and Maintenance Manual
(Pump JET 150L)
: 52 l/min at 25 m
GB
2