Operation; Filling The Water Tank - Silvercrest SEM 1100 B3 Instrucciones De Uso

5) Insert the plug into a mains power socket .
6) Proceed as follows before the first use, so as to clean the internal pipelines:
Allow sufficient water for about 5 cups of espresso (about 100 ml) to flow
through the appliance . Refer to the section "Operation" .
7) Let the appliance generate steam for about 30 seconds . Refer to the section

"Operation" .

NoTE
► When using the appliance for the first time, it is possible that you can hear
the pump working, even though no water comes out of the appliance . If this
is the case, turn the steam control 7 in the direction of the " + ", so that the
air can escape from the pipes of the appliance (the "Steam" button
is pressed) . After approx . 20 seconds the air will have escaped, the noises
disappear and water flows from the appliance .
operation
NoTE
► Both the "Espresso"
pressed in . If the button is pressed again, it is released .

Filling the water tank

NoTE
► Use only fresh drinking water for making espresso/cappuccino .
1) Pull out the water tank 9 out and fill it with water:
Fill it with water to at least the Min marking .
Never fill it past the Max marking .
2) Push the water tank 9 back into the appliance . Ensure that the hose is inside
the water tank 9 .
■ 82 │ GB │ MT
3 and the "Steam" 4 buttons engage when
SEM 1100 B3
4