Descargar Imprimir esta página

Lutron HOMEWORKS Sivoia QED Instrucciones De Instalación página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

10. Check For Sivoia QED
TM
QED Communication LEDs (RX and TX) are normally
off, and will blink when an event occurs. After the limits
have been set for each Sivoia QED shade, verify Sivoia
QED communication link wiring. Press either the All
Open or All Close button on the HWI-Q96. Any Sivoia
QED shades that are properly wired (even if they are not
addressed) should open or close. Double tap either the
All Open or All Close button to stop the shade
movement. Check the Sivoia QED Communication LEDs
(TX and RX). The Status LED will be on during normal
operation and blinking when in Address Mode.
11. If the connected Sivoia QED system works intermit-
tently with the HomeWorks processor, check link
wiring and HWI-Q96 / HomeWorks processor termi-
nation.
Figure 2 - LT-1 Installation
HomeWorks
Terminal Block wiring for furthest
HWI-Q96/HWI-H48
Technical and Sales Assistance
If you need assistance, call the toll-free Lutron Technical
Support Center. Please provide exact model number when
calling.
1.800.523.9466 (U.S.A., Canada and the Caribbean)
Other countries call:
Tel:
610.282.3800
Fax:
610.282.3090
Visit our Web site at www.lutron.com
Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036-1299
Made and printed in the U.S.A. 11/05 P/N 043-186 Rev. B
Communication. The Sivoia
processor H48 Link
®
Figure 3 - DIP Switch Settings
Set DIP switches 5-6 to give the HWI-Q96 a unique HomeWorks
H48 Link address from 1 to 4. DIP Switches 1-4 should always be in
the OFF (DOWN) position.
Address
Switch
#
Settings
ON
Example: Setting Switch #5 ON.
1
1
2
3
4
5
6
ON
2
1
2
3
4
5
6
ON
ON
3
1
2
3
4
5
6
1
2
ON
4
1
2
3
4
5
6
Figure 4 - System Wiring
HomeWorks
processor H48 Link
Terminal Block
To HomeWorks
processor H48 Link
Two pair 18 AWG (1.0 mm
2
) twisted
and shielded Class 2 wire. Lutron wire
model # GRX-CBL-346S-500 may be
used so long as one of the 18 AWG
wires is used for Common (terminal 1).
Max. 1000 ft. (305 m) total wire run
distance. Daisy-chain wiring configura-
tion only.
LIMITED WARRANTY
(Valid in the U.S., Canada, Puerto Rico, and the Caribbean.)
Lutron will, at its option, repair or replace any unit that is defective in materials or manufacture
within two years after purchase. For warranty service, return unit to place of purchase or mail to
Lutron at 7200 Suter Rd., Coopersburg, PA 18036-1299, postage pre-paid. Telephone the
Lutron Technical Support Center toll free at 800-523-9466. After the two year period, a pro-rated
warranty applies to this product until eight years after the purchase. For more information regard-
ing this warranty contact your Lutron representative.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND THE IMPLIED
WARRANTY OF MERCHANTABILITY IS LIMITED TO TWO YEARS FROM PURCHASE.
THIS WARRANTY DOES NOT COVER THE COST OF INSTALLATION, REMOVAL OR REIN-
STALLATION, OR DAMAGE RESULTING FROM MISUSE, ABUSE, OR IMPROPER OR
INCORRECT REPAIR, OR DAMAGE FROM IMPROPER WIRING OR INSTALLATION. THIS
WARRANTY DOES NOT COVER INOPERABILITY RESULTING FROM INTERFERENCE,
INCORRECT INSTALLATION, OR ENVIRONMENTAL FACTORS. THIS WARRANTY DOES
NOT COVER INCIDENTAL OR CONSEQUENTIAL DAMAGES. LUTRON'S LIABILITY ON
ANY CLAIM FOR DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE MANU-
FACTURE, SALE, INSTALLATION, DELIVERY, OR USE OF THE UNIT SHALL NEVER
EXCEED THE PURCHASE PRICE OF THE UNIT.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state. Some states do not allow limitations on how long an implied warranty lasts, so the
above limitation may not apply to you. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply to you.
This product may be covered by one or more of the following U.S. patents: 4,889,999;
5,170,068; 5,237,207; 6,803,728; 6,917,167 and corresponding foreign patents. U.S. and for-
eign patents pending.
Lutron, HomeWorks, Sivoia, and the sunburst logo are registered trademarks and Sivoia QED
and SOLos are trademarks of Lutron Electronics Co., Inc.
© 2005 Lutron Electronics Co., Inc.
UP (ON)
DOWN (OFF)
3
4
5
6
Sivoia QED
Communication Link
Terminal Block
To Sivoia QED
Communication Link
Two pair (four conductor) 18 AWG
(1.0 mm
2
) twisted and shielded Class 2
wire. Lutron wire model # GRX-CBL-
346S-500 may be used so long as the
18 AWG wires are used for +12V and
Common (terminals 1 & 2).
Max. 4000 ft. (1220 m) total wire run
distance for the Sivoia QED system.
Home run or daisy-chain wiring config-
uration.

Publicidad

loading

Este manual también es adecuado para:

Hwi-q96