Ryobi RY34007 Guia De Inicio Rapido

WARNING:
This Engine Starting Procedure is not a substitute for
reading the operator's manual. To reduce the risk of injury, user must
read and understand operator's manual before using this product.
Cold Engine:
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
1
Later uses: Check engine lubricant level and add lubricant if needed.
LUBRICANT
Carefully pour fuel into the tank. Avoid spillage.
2
Immediately replace fuel cap and hand tighten.
1 GALLON
Wipe up any fuel spillage.
GAS
PRIME
3
10x
slowly.
SET
4 CHOKE lever to " FULL CHOKE "
position. Do not squeeze throttle trigger.
5 With throttle at idle,
until engine runs. (Max 3 times)
• If 60°F or lower, continue to pull starter grip until
engine runs.
HALF
• If above 60°F, set CHOKE lever to "HALF
CHOKE
CHOKE" and pull starter grip until engine runs.
6
RUN
After 10 seconds,
position.
Warm Engine:
Press the PRIMER BULB 10 times
slowly. Set choke lever to RUN. Pull
RUN
starter grip until the engine runs.
10x
To Stop:
DEPRESS the "STOP" switch to the STOP position
990000697
8-6-13 (REV:01)
press the PRIMER BULB 10 times
PULL
starter grip sharply
SET
CHOKE lever to RUN
ENGINE STARTING PROCEDURE
NOTICE
Do not use E15 or E85 fuel (or fuel
containing greater than 10% ethanol) in
this product. It is a violation of federal
law and will damage the unit and void
your warranty.
1
Go to www.ryobitools.com and register your new tool on-line. For any questions about
operating or maintaining your product, call the Ryobi
fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips
are also available in your operator's manual. For additional registration instruction, refer
to operator's manual.
5
4 6
5
2
4
Help Line! Your Product has been
®
RUN
HALF
CHOKE
FULL
CHOKE
3