Bravo Uniko Manual Del Usuario página 4

Batterles:
This product requires 2 AAA/LR03 Alkaline batteries. Please pay attention
to the polarity +/-.
ATTENTION: to keep the codes stored inside the memory do not press
key during batteries replacement.
DIRECT CODE ENTRY
DTT/SAT
1. Turn on the device.
2. Look for the brand of the device you want to program in the code list and
a note of the first code in the list (e.g Digiquest – 4303).
3. Press and hold the device [DTT/SAT] key of URC around 5 seconds until
LED goes on. Then release.
4. When the LED goes on in step 3, enter the previously identified code (e.g.
4303) from the code list.
If LED turns off, it indicates that the code is accepted. (If LED flashes 3 times
and then turned off, it indicates the code is unaccepted. Repeat from Step 3).
Then press [POWER] of URC to see if it can turn off the device. If it can turn
off the appliance, it means the code is correct; if not, please repeat from
step 2 to try another codes.
N.B. THE LED STOPS FLASHING.
The remote control exits programming mode and the LED stops flashing if
no keys are pressed for 15 seconds.
POWER AUTO-SEARCHING
This operation can take up to 20 minutes and should be carried out if you
havenot succeeded in programming the remote control by means of "Direct
code entry".
1. Turn on the appliance to be programmed.
2. Press and hold the the [DTT/SAT] key around 5 seconds until LED goes on.
Then release.
3. When LED goes on in step 2,Hold the remote control and aim to the device.
the Press and slowly release the [POWER] key, LED flash once every
two seconds.
4. When the appliance powers off, it indicates that the code is found.