Bravo Uniko Manual Del Usuario página 5

5. Press [DTT/SAT] key immediately to confirm. LED turns off.
6. Switch on the device and check the various keys on the remote, if the
found code is not correct please repeat from step 2
If the end of the code search list has been reached. In this case, start again
from Step 2.
In case you forget the codes entered in the URC, please follow these steps to
find out the 4 digits codes .
1. Press and hold [DTT/SAT] key then press OK, release both of them, led
will flash once.
2. Led will indicate the digit code with a series of flashes separated by a brief
pause.
Ex code 1380:
- 1 flash followed by a pause of 1 sec.
- 3 flashes followed by a pause of 1 sec. = 3
- 8 flashes followed by a pause of 1 sec. = 8
- 10 flashes followed by a pause of 1 sec. = 0
3. Please take note of the 4 digits code in order to re-insert in case of loss
of memory during batteries replacement.
Note: To copy the codes from the original remote control, the TV remote
must be working.
1) Press and hold LEARN button for about 4 seconds until the LED begins
2) Place UnikO in front of the remote control that you want to copy at a
distance of about 2 cm.
3) Press on UnikO the button you want to copy (e.g ON/OFF button UnikO),
the LED stays lit.
4) Press and hold the button on the original remote that you want to copy
( e.g ON/OFF button - Philips TV).
- If the LED on the remote control UnikO emits a double blink and then
to flash rapidly the code has been copied successfully.
- If the LED on the remote control UnikO emits a triple flash and then
then remain lit the code was not copied.
5) Repeat the procedure from step 3 to copy the other 6 buttons available.
CODE REMINDER
LEARN FUNCTION FOR TV KEYS
= 1