NUTOOL NCS185 Traducción De Las Instrucciones Originales página 20

GB
unprotected, coasting blade will cause the saw to walk
backward, cutting whatever is in its path.
Be aware of the time it takes for the blade to stop after the
switch is released.
WARNINGS
Before connecting a tool to a power source (mains switch power
point receptacle, outlet, etc.) be sure that the voltage supply is
the same as that specified on the nameplate of the tool. A power
source with a voltage greater than that specified for the tool can
result in serious injury to the user, as well as damage to the tool.
If in doubt, do not plug in the tool. Using a power source with a
voltage less than the nameplate rating is harmful to the motor.
Your tool is double insulated for additional protection against a
possible electrical insulation failure within the tool.
Always remove the plug from the mains socket before making
any adjustments or maintenance, including changing the blade.
• When operating the saw, use safety equipment including
safety goggles or shield, ear protection, dust mask and
protective clothing including safety gloves.
• Do not use this saw to cut firewood.
• Ensure that the lighting is adequate.
• Keep the area free of tripping hazards.
• Do not let anyone under the age of 18 years operate this
saw.
• Always stand to one side when operating the saw.
• Never use a cracked or distorted saw blade. Only use sharp
blades.
• When cutting round wood, use clamps that prevent the work
piece from turning on both sides of the blade.
• Never use your hands to remove sawdust, chips or waste
close by the blade.
• Use only blades as recommended.
• Do not use blades of High Speed Steel (HSS blades)
• Rags, cloths, cord and string and the like should never be left
around the work area.
• Avoid cutting nails. Inspect the work piece and remove all
nails and other foreign objects before beginning sawing.
• Support the work properly.
• Never reach over the blade to remove waste or off cuts.
• Do not attempt to free a jammed blade before first switching
off the machine.
• Do not slow or stop a blade with a piece of wood. Let the
blade come to rest naturally.
• If you are interrupted when operating the saw, complete the
process and switch off before looking up.
• Periodically check that all nuts, bolts and other fixings are
properly tightened.
• Do not store materials or equipment above a machine in
such a way that they could fall into it.
• Always hold the saw on parts that are insulated.If you
accidentally cut into hidden wiring or the saw 's own cable,
the metal parts of the saw will become "live ".
• Never saw near combustible liquids or gases.
• Note the direction of rotation of the motor and the blade.
• Do not lock the movable guard in the open position and
always ensure that it is working properly, freely rotating and
returning to fully cover the teeth of the blade.
• Do not use any abrasive wheel unless the machine is
designed for that purpose.
The tool must be used only for its prescribed purpose. Any use
other than those mentioned in this Manual will be considered
a case of misuse. The user and not the manufacturer shall be
liable for any damage or injury resulting from such cases of
misuse.
The manufacturer shall not be liable for any changes made to
the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to
eliminate all residual risk factors.
The following hazards may arise in connection with the
tool's construction and design:
• Contact with the blade.
• Kickback of workpiece and parts of workpiece.
• Blade fracture
• Catapulting of blade pieces.
• Damage to hearing if effective ear defenders are not worn.
• Harmful emissions of sawdust when the machine is used
in closed rooms. Always use supplementary dust extraction
where possible.
20