Cutting Techniques - BaByliss E860XE Manual Del Usuario

the stand and connect it
directly into one of the two
units.
Plug the trimmer or precision
pen, in the OFF position, into
the mains and switch ON (If
the battery is very weak, wait
about 1 minute).
IMPORTANT! Use only the
transformer
the Kit E860XE Voltage = 3V
– Tension = 600mA (Fig.1)
HANDLING
GUIDE
The comb guide is very
practical and guarantees an
even cutting length.
NOTE: Always put the comb
guide on BEFORE turning
the trimmer on, and turn the
trimmer off before removing
it.
To remove or replace the
comb guide, first set the
comb guide to double triangle
mark (Fig. 2) and, with the
motor off, pull the guide up to
remove (Fig. 3) it, press the
guide down then turn the dial
to put it on (Fig. 4).
HANDLING THE HEADS OF
THE PRECISION TRIMMER
Make sure the precision pen
is turned off before changing
the cutting head.
1. In the closed position, hold
the body of the unit and
turn the head in a counter-
clockwise direction, in the
direction of the mark on
provided with
THE COMB
the cutting head (on the
back of the unit).
2. Remove the cutting head.
3. To replace
head,
the unit with the marks
properly aligned then turn
in a clockwise direction, in
the direction of the mark
on the cutting head, until
you hear a 'click'.
TURNING
USING IT
To adjust the cutting length of
the clipper, turn the dial; the
selected height will appear in
the little window above the
dial.
Switch the ON/OFF button
and select speed I or speed
II. (Fig. 5)
You can change the cutting
length at any time.
NOTE! Make sure you hold
the comb head flat against
the skin. That is, the tips
of the teeth and the little
corners protruding from the
comb should always be in
contact with the skin. If not,
the precision of the cut may
change.
(Fig. 6-7-8)

CUTTING TECHNIQUES

For the beard or moustache
just the way you want it...
Decide on the type of beard
or moustache
suits your face taking into
account the size of your
7
the cutting
press down
IT ON
that
on
AND
best