Sony MDR-DS4000 Manual De Instrucciones página 25

Symptom Cause and remedy
, The EFFECT switch on the processor is set to "OFF."
The DOLBY PRO
LOGIC II indicator
, Analogue input signal, digital input PCM signal, Dolby Digital 2-channel
does not turn on
The DOLBY PRO
, The EFFECT switch on the processor is set to "CINEMA" or "MUSIC" mode.
LOGIC II indicator
, Analogue input signal, digital input PCM signal, Dolby Digital 2-channel
turn on
The DTS indicator
, The DTS digital output setting on the DVD player (including game machines)
does not turn on
, Playback signals are not recorded in DTS format.
, The audio for the chapter being played is not a DTS signal.
, The DVD player does not support DTS format.
, Playback signals are not recorded in MPEG-2 AAC format.
MPEG-2 AAC
indicator does not
light up.
, Check if the CHG indicator turns on. If not, put the headphones on the
The batteries
cannot be
charged
, Dry batteries are installed.
, Rechargeable batteries other than the supplied are installed.
, The CHG indicator remains lit during charging (approx. 16 hours) by the
The CHG indicator
does not turn off.
, Signal noise is output from the connected analogue component.
Infrared signal
emission does not
stop (when the
INPUT SELECT
switch on the
processor is set
to "ANALOG")
, No power supplied to the processor.
No signal from
optical digital
output
, No playback sound from the connected external digital unit at the optical
, Connect the analogue out to the LINE IN jack, and select the sound on the
Bilingual sound
cannot be selected
when using digital
input. (Both MAIN
and SUB can be
heard at the same
time.)
signal or MPEG-2 AAC 2-channel signal is not input.
signal or MPEG-2 AAC 2-channel signal is input.
is set to "OFF."
• See the instruction manual of your DVD player, and change the DTS digital
output setting to "ON."
• Use a DVD player that supports DTS.
processor correctly so that the CHG indicator turns on.
• Insert the supplied rechargeable nickel-metal hydride batteries.
• Insert the supplied rechargeable nickel-metal hydride batteries.
built-in timer after the headphone is placed on the processor.
• Unplug the connected analogue component, or set the INPUT SELECT
switch on the processor to "DIGITAL," and make sure playback of the
component connected to the DIGITAL IN jack is stopped.
• Connect the processor to a power source.
input jack.
• Check the external unit is playing back.
connected component.
Additional Information
GB
25