Safety System; Using The Appliance - essentiel b ECTF 5 Multivita Manual De Instrucciones

CAUTION: the safety precautions are part of the
appliance. Read them carefully before using your
new appliance for the first time. Keep them in a place
where you can find and refer to them later on.
DESCRIPTION
A Pusher
B Feed tube
C Cover
D Sieve
E Juice collector
F Pouring spout

SAFETY SYSTEM

To start the juicer, the cover (C) must be
fitted correctly (Fig. 2).
At the end of a cycle, turn the control
button to "0" and wait until the sieve (D)
BEFORE FIRST USE
We recommend that you wash the
removable parts (A, B, C, D, E, F, G, H)
before the first use (see section "Cleaning
and care").

USING THE APPLIANCE

• Place the juice
on the body of the appliance
(see Fig. 1).
• Place the sieve (D) in the juice collec-
tor (E). Ensure that the sieve is pro-
perly clipped onto the drive shaft (K)
(see Fig. 1).
• Fit the cover (C) on the appliance in
order to have the pulp evacuation exit
G
H
I
J
K
L
stops completely before removing the
cover (C).
• Unpack the appliance and then place it
collector (E)
• Fit the pulp collector (H) on the rear of
• Lock the two clamps (I) on the cover
• Slide the pusher (A) into the feed tube
5
Non-drip spout
Pulp collector
Safety clamps
Control button
Drive shaft
Motor unit
on a solid, stable worktop, remove the
cover (C) and take out the protective
card on the sieve (D).
to the rear (see fig.2).
the appliance (see Fig. 3).
(C). You will hear an audible "click"
(see Fig. 4).
(B) aligning the groove on the pusher
with the small ridge in the feed tube.