Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Place the saw blade in the blade holder.
•
Let go of the clamping ring.
•
Make sure when changing the saw blade that
the blade holder is free of material debris
(such as splinters of wood or metal).
•
Before use, always check that the saw blade is
securely fixed.
Removing the saw blade
•
Turn the clamping ring of the saw blade holder
as far to the left as possible and hold it there.
•
Remove the saw blade from its holder.
•
Let go of the clamping ring.
Mounting and removing the parallel guide
(fig. C)
The parallel guide is used for sawing along edges
at a maximum distance of 16 cm.
Mounting
•
Slacken the Allen screws (8) using the Allen
key (11).
•
Insert the parallel guide (16) into the saw shoe
(7).
•
Set the parallel guide (16) to the required
position.
•
Tighten the Allen screws (8) using the Allen
key (11).
Removing
•
Slacken the Allen screws (8) using the Allen
key (11).
•
Remove the parallel guide (16) from the saw
shoe (7).
•
Tighten the Allen screws (8) using the Allen
key (11).
USE
Switching on and off (fig. A)
● To switch on the machine, press the on/off
switch (1).
● To switch the machine to continuous mode,
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
● To switch off the machine, release the on/off
switch (1).
Setting the sawing speed (fig. A)
The speed adjustment wheel is used for setting
the sawing speed. The speed adjustment wheel
can be set to 6 positions. The ideal sawing speed
depends on the profile and the teeth of the saw
blade and on the material to be worked.
2
Do not set the sawing speed during use.
● Turn the speed adjustment wheel (3) to the
required position.
● For hard materials, use a saw blade with fine
teeth and select a lower speed.
● For soft materials, use a saw blade with
coarse teeth and select a higher speed.
Setting the mitre angle (fig. D)
The mitre angle is variable between -45° and
+45°.
2
Do not set the mitre angle during use.
● Slacken the Allen screws (17) using the Allen
key (11).
● Tilt the saw shoe (7) to the required position.
● Tighten the Allen screws (17) using the Allen
key (11).
Using the pendulum action switch (fig. A)
The pendulum action switch is used to set the
way in which the teeth of the saw blade grip the
material. The pendulum action switch can be set
to 4 positions.
2
Do not set the pendulum position during
use.
● Turn the pendulum action switch (4) to
required position according to the material to
be worked. Refer to the table below to select
the required position.
Material
Wood
Plastics
Aluminium
Steel
Ceramics
Rubber
Dust extraction (fig. E)
● Insert the dust extraction adapter (18) into the
dust extraction connection (9).
● Connect the hose of a vacuum cleaner to the
dust extraction adapter (18).
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
Pendulum position
1-3
1
0-1
0
0
0
7
Publicidad
Tabla de contenido
