How To Operate - Mercalor MT 01 503 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Should the unit overheat, this heater is fitted with a safety with overheating device
which will switch the off automatically. (If the air vent is blocked or if the fan function is not
blowing air). If this should happen, all you need to do this:
Disconnect the plug from the electrical socket for a few minutes. Ensure the heater is not
covered and nothing is obstructing any of the vents. Plug the heater back into the electrical
socket and switch the heater back ON.
KEY PARTS AND POSITION
1. Knob ON / OFF and functions (left side)
2. Thermostat knob (right side)
3. Front of grid and PTC element.
4. Base with security button.

HOW TO OPERATE

1. Remove the unit from the box and take off any protective wrapping.
2. Place the heater on a smooth level surface and least 30cm away from any obstacles.
3. Plug your fan heater into the power supply. Make sure your power supply corresponds to
the power indicated on the rating label.
4. Heat temperature setting can be regulated using the switch located on the top of the
heater. This switch is use for both the fan and heat elements. Note the fan speed cannot
be altered and will always remain constant. To turn the application on:
a. Fan-for a lower power air circulator; Turn the dial on the right clockwise, once for the
fan function
b. Low-Turn it twice for the Medium heat setting (750W). The setting is best suited for
smaller, well-insulated areas that require less warning.
c. High-Turn the switch once more for High setting, or full power (1500W). Which delivers
rapid warm air to increase the temperature to a given area.
OVERHEATING SAFETIN DEVICE
Your heater is fitted with a safety device that switches off the heater in the event of
overheating.
Should the heater stop working, turn the heater off and inspect of blockage of inlet or
outlet. Wait at least 5 minutes of the protection system to reset before attempting to restart
the heater.
If the heater fails to operate the safety device switches the heater off again, return the heater
to your nearest service center for examination or repair.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido