Introduction; System Installation - Airzone AZCE6BLUEFACEC Guía De Instalación Rápida

INTRODUCTION

Airzone systems enable the management of Master and Zone interfaces. Master thermostats enable mode management or
define the efficiency level with the Eco-Adapt function.
It is recommended to use of a Blueface thermostat as Master Interface, this enables time schedule management and more
unique functionalities.
Remember: This system has to admits one Master thermostat.
To distinguish a Master Interface from a Zone Interface, check the next points:
- Blueface Master: Mode, Eco-Adapt and Speed* icons shown in white color.
- Blueface Zone: Mode, Eco-Adapt and Speed* icons shown in gray color.
- Think Master: Accessing the settings menu, Operation mode and Speed* are available.
- Think Zone: Accessing the settings menu, Operation mode and Speed* are unavailable.
*Note: Only available in installations with Fancoil.

SYSTEM INSTALLATION

Before performing the Airzone system installation, check:
· The equipment to control has been installed according to the manufacturer's criteria and it works correctly without
the Airzone system.
· In direct expansion unit systems, the indoor unit wired thermostat has been installed.
In order to install the Airzone system, carefully follow these steps:
Install the Easyzone (see section Easyzone assembly).
- Attach the Easyzone to the indoor unit.
- Install the flexible duct and the air diffusion elements.
Connect all the necessary elements (see section Main control board connection).
- Connect the communication gateway to the indoor unit.
- Connect all the elements of the system (thermostats, modules, etc.).
- Power the main control board.
Check all the assembly and the connection are correct (see section Assembly and connection evaluation).
Configure the system.
- Configure all the thermostats (see sections Initial configuration and Advanced settings).
If you have any other doubt, check the user and installation manuals.
It does not require any maintenance.
ES
EN
FR
IT
PT
DE
21