Descargar Imprimir esta página

ROBBE POWER PEAK ULTIMATE Li 8427 Li Manual De Instrucciones Adicional página 12

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

If you set a charge current higher than 1 C,
the charger automatically limits the value to 1
C. However, it is possible to set lower charge
currents manually.
Press the Enter button -> the arrow flashes.
You can now reduce the charge current in
increments of 100 mA using the +/- buttons.
The smallest value you can set is 0.1 A, the
maximum 5.0 A, but the maximum value is
limited by the preceding capacity setting and
the battery voltage.
Press the Enter button again after making
your selection.
Storing the settings
Press the "+" button to leaf through the
screen display until the arrow indicates End.
Press the Enter button to store the settings
you have selected.
Starting the charge process
The screen display reverts to the starting
point.
- Press the "MAN" button.
- The Start display appears.
- Press the Enter button to select the dis-
played spot memory; the screen shows the
stored parameters so that you can check
them.
Press the START button to initiate the charge
process.
Supplementary operating instructions
POWER PEAK ULTIMATE Li
12
The working display now appears on the
screen.
The screen shows:
Status
Capacity
Battery voltage
Charge
current
The charge process is stopped by the auto-
matic charge termination circuit; alternatively
you can interrupt it by pressing the STOP
(ENTER) button.
The status display then changes from C =
Charge to F = Finished.
Specification:
Input:
Cell count:
Lead-acid battery:
Lithium battery:
Charge current:
Discharge current:
Charge termination:
NC / NiMH:
Lead-acid /
Lithium batteries:
Dimensions:
Order No.
8427 Li
Time hr:min:sec
Battery type
11 - 15 Volts DC
NC / NiMH bat-
tery: 1 ... 25 cells
1 ... 6 cells
1 ... 4 cells
0.1 ... 5 A
0.5 ... 3 A
Automatic
Digital Delta-Peak
Voltage-
dependent
155x125x55 mm

Publicidad

loading

Este manual también es adecuado para:

Power peak ultimate li8427 li