Eneral Notes On Safety; U - Purposes For Which It Is Intended; I Ncorrect Use; Ec Ce - SUHNER ABRASIVE LFC 11 Documentación Técnica

1. N
1.1 g

enerAl notes on sAfety

This operation manual is applicable for the machine LFC
11.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machine is designed for sawing, filing, polishing, and
lapping work with saw blades, files, polishing wheels, and
other attachments within the given specifications. It can
work any material that does not pose a hazard to health
or the power tool.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. C
2.1 P

rior to tAking the mAchine into service

Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.2 t
Aking the mAchine into service
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
16
S
oTES oN aFETy
ommISSIoNINg
ing the lever will shut the machine down.
2.3 r

Ating dAtA

Pressure
Power output
Frequency stroke
Stroke
Air consumption
Setting oiler idle
Sound pressure level EN ISO 15744 74dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Lenght
Weight with hose
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
haNDLINg
3.1 t
ools
Use only clean tools!
3.1.1 c /f
hAnging itting the tool
Insert the attachment to the stop in the tool holder and
tighten the securing screw with 2.5–3 Nm. After securing
the attachment check that all external moving parts do
not collide with any stationary parts. Check the torques on
the securing screws at regular intervals and if necessary
tighten these. The attachment may not weigh more than
20 g. The attachment's shaft may be no less than 0.1 mm
smaller than the nominal size.
max. 6.3bar
~300W
100-200Hz
2-11mm
about 0.23m /min
3
about 1 drops/min
2.2m/s , K=0.8m/s
2 2
3/4/4
280mm
0.830kg
/ o
PERaTIoN