Matco Tools LOWZC450 Manual Del Usuario página 3

PREPARATION
Before assembling your Folding Creeper, make sure all parts are present. Compare parts with package contents
list and illustrations. If any part is missing or damaged, do not attempt to assemble, install or operate the product.
Call Matco Tools tech. service (866) BUY-TOOL for replacement parts. Packaging Contents: 1 Creeper Body with
cushions, 6 Casters, 6 Caster Lock Nuts.
ASSEMBLY
1. Carefully unfold the creeper until flat. Engage spring loaded Locking Pins.
CAUTION: Folding components can present pinch and crush hazards during normal use of this product. Exercise
!
caution when performing adjustments and while assembling and using this equipment.
2. Attach casters to creeper frame caster brackets
using 17mm nuts.
OPERATION
1. Locate and unlock spring loaded Locking Pin for
middle section by pulling out until disengaged.
Then rotate Head Frame and Middle Frame upward
as shown in Fig. 1 until the Locking Pin can engage
hole in Creeper Seat locking plate (ensure Lock Pin
is fully engaged). This is the low seat configuration.
2. Disengage Lock Pin for Middle Frame and rotate fur -
ther forward. Engage locking pin. Disengage Lock
Pin for Head Frame section and rotate backwards
as shown in Fig. 2. Adjust hinged caster brackets
as required. This is the high seat configuration.
CAUTION: Ensure all Lock Pins are properly
engaged before using creeper.
!
Figure 1 - Low seat configuration
MAINTENANCE
Wipe clean as needed. Use mild upholstery cleaner (not caustic) to clean cushions.
!
CAUTION: Do not add lubricant to casters.
Figure 2 - High-seat configuration
Figure 3 - Creeper configuration
3. Adjust hinged caster brackets so wheels will contact
ground properly. Unlock spring loaded Lock Pins,
then reverse steps 1 and 2, as shown in Fig. 3, to
convert Creeper Seat into Creeper.
Page 3
1908256-35