Technical Data - YATO YT-85120 Manual De Instrucciones

SPECIFICATION OF THE PRODUCT
Pole pruner is a type of chain saw, used to care for tree crowns. It allows to cut small branches in places inaccessible to traditional
pole pruners. Because its operation is much quieter than in the case of combustion tool, its operation is also possible in vicinity
of buildings. Due to the battery power supply, the pole pruner allows you to work in areas, which are not accessible for to mains-
powered products. Correct, reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damages or injuries caused by the tool misuse, resulting from failure to comply with its designation, non compliance with
with safety regulations and recommendations included in this manual, the supplier does not accept any liability. The tool misuse
causes also the loss of user's rights to the guarantee and warranty.
PRODUCT EQUIPMENT
The product is supplied in a complete state but before the first use it is required to assembly it.
Along with the pole pruner there are supplied:
- chain guide
- cutting chain
- guide shield
- battery
- charging station
- belt harness

TECHNICAL DATA

Parameter
Catalog number
Rated voltage
Speed of the chain travel
Rotational speed
The length of guide bar
Chain scale
Chain spread
Chain type
Type of the chain guide
Number of teeth of the chain drive wheel and scale
Electric protection class
Degree of protection
Oil tank capacity
Weight (without the battery, guide and chain)
Noise level
- L (pressure)
pA
- L (power)
wA
Vibration (rear handle/front handle)
Type of the battery
Capacity of the battery
Energy of the battery
Charging station
Input voltage
Mains frequency
Rated power
Output voltage
Input current
Time of charging
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
O R I G I N A L
GB
Unit
[V]
[m/s]
[min ]
-1
[mm /'']
[mm]
[mm]
[cm ]
3
[kg]
[dB (A)]
[dB (A)]
[m/s ]
2
[mAh]
[Wh]
[V]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-85090
18 DC
3 2
1800
200 / 8
9.525
19
91PJ033X / 9P033X, Oregon
080SDEA041, Oregon
7 teeth x 9.525 mm
III
IP20
60
4.0
78.8 ± 3.0
90.7 ± 2.36
2,68 ± 1,5 / 4,84 ± 1,5
Li-ION
3000
54
230~
50
42
18 D.C.
1.7
2
13