X.ADdendum - Hyundai HY-CLM09KR-001 Manual De Usuario

In dehumidification mode, the ambient
temperature is low.
There is direct sunlight.
Doors or windows are open; there are a
The cooling lot of people; or in cooling mode,
effect is not there are other sources of heat.
good The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed on
Big Noise
a flat surface.
compressor does
Overheat protection starts.
not work.
The distance between the machine and
the remote control is too far.
The remote
The remote control is not aligned with
control does not
the direction of the remote control
work.
receiver.
Batteries are dead.
Displays 'E1'. The
abnormal.
Displays 'E2' The
abnormal.
Note: If problems not listed in the table occur or recommended solutions do not work, please contact the
professional service organization.

X.Addendum

Schematic diagram for air conditioning
（The specific technical parameters of the machine shall be subject to the nameplate on the product）
Compresso
Treatment: Don't put the abandoned machine with other unsorted waste together. Such waste shall be placed
separately for other special use.
Declaration of conformity EU:
Market Maker Brand Licensing, hereby declares that this equipment, conforms to the essential
requirements and other relevant provisions of Directive 2014/53/UE. The declaration of Conformity can
be viewed at the following address:
http://www.mms-support.net/OTA/ECD_MMBL_ HY-CLM09KR-001 .pdf
pipe temperature sensor
room temperature sensor
Condense
Licensed by HYUNDAI Corporation Holdings, Korea
Imported/distributed by MARKET MAKER GROUP S.A.
The machine is placed in a room with an ambient
temperature of greater than 17 ℃ (62 ℉).
Pull the Curtain.
Close doors and windows, and add new air
conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat and hard
place (to reduce noise).
Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
Let the remote control get close to the air
conditioning, and make sure that the remote
control directly faces to the direction of the
remote control receiver.
Replace batteries.
is Check the pipe temperature sensor and related
circuitry.
is Check the room temperature sensor and related
circuitry.
Capillary
Evaporat
39