Starting And Stopping - Troy-Bilt TB635 EC Manual Del Operador

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

WARNING:

Operate this unit only in a well-ventilated

outdoor area. Carbon monoxide exhaust fumes can be

lethal in a confined area.

WARNING:

Avoid accidentally starting the unit. To avoid

serious injury, the operator and the unit must be in a stable

position when pulling the starter rope (Fig. 10).

STARTING INSTRUCTIONS

1. Check the oil level. Refer to Checking the Oil Level.

2. Fill the fuel tank. Refer to Fueling the Unit.

NOTE: There is no need to turn the unit on. The On/Off switch is in

the On ( I ) position at all times (Fig. 8).

3. Slowly press and release the primer bulb 10 times (Fig. 9).

4. Crouch in the starting position (Fig. 10).

NOTE: PRESS and HOLD the throttle lockout, then SQUEEZE and

HOLD the throttle control for ALL further steps.

NOTE: To prevent the throttle control from being squeezed

accidentally, this unit has a throttle lockout. The throttle control

cannot be squeezed unless the throttle lockout is also engaged.

5. Press and hold the throttle lockout (Fig. 8). Squeeze and hold

the throttle control (Fig. 8).

6. Continue to hold the throttle lockout and throttle control. Pull the

starter rope with a controlled and steady motion 5 times to start

the engine (Fig. 10).

IF... the engine does not start, begin the starting procedure with step 3.

IF... the engine fails to start after 3 attempts: Press and hold the throttle

lockout. Squeeze and hold the throttle control. Pull the starter rope

with a controlled and steady motion until the unit starts.

IF... the engine stops while the throttle control is squeezed, begin

the starting procedure with step 3.

IF THE ENGINE IS HOT... begin the starting procedure with step 3.

STOPPING INSTRUCTIONS

1. Release the throttle control and allow the engine to idle.

2. Press and hold the On/Off switch in the Off (O) position until the

engine comes to a complete stop (Fig. 8).