Rowenta ACCESSIM EP5820E0 Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
NOT EP5820E0 017455
USE
GB
3 • Leg hair removal
For optimum epilation, we recommend that you tilt the epilator slightly
towards your skin in the direction of epilation (fig.3).
Move the switch to the on position 2 (fig.4).
The switch must always remain visible during use (fig.5).
Shave against the lie of the hair, with the shaver perpendicular to your skin (fig.6).
When depilation completed, stop the appliance (fig.7).
4 • Hair removal from sensitive areas
For optimum epilation, we recommend that you tilt the epilator slightly towards
your skin in the direction of epilation (fig.8).
A- With the epilator:
If the hairs are long trim to approximately 1cm.
Dry the area thoroughly to ensure any trace of deodorant or perspiration are
removed.
Move the switch to the on position 1 (fig.9) and shave against the lie of the hair,
slowly and without pressing, with the shaver perpendicular to your skin.
• For the armpits :
- make sure the skin is stretched properly, and keep your arm raised and stretched
throughout the hair removal.
- first shave from bottom to (fig.10) ...then from top to bottom (fig.11).
• For the bikini line:
- make sure the skin is stretched properly (fig.12).
IMPORTANT
Small red spots may appear. They will disappear quickly. It is preferable to use
your depilator in the evening. If necessary, apply calming cream after depilation.
B-With the shaver head:
Operating instructions:
- Remove the epilator head by pressing the ejection button
- Fit the shaver head (10) onto the appliance (fig.29)
- Set the switch to position 2.
- After use, stop the appliance.
- To remove the shaver head: Press the release button on the head and pull
upwards (fig.30).
5 • Peeling
Peeling will enable you to limit growth of subcutaneous hair if practised regularly.
Press the release button to remove the epilator head (fig.14).
Clip the Exfoliator Head to the epilator (fig.15). Set the switch to 1 (fig.16) and
start exfoliating with a slow, gentle up and down movement (fig.17).
After peeling, we advise you to wipe over the area with a moist flannel to remove
any dead skin (fig.18) and dry the skin thoroughly afterwards.
When using the Micro-Peeling function for the first time or if your skin is very deli-
cate, we recommend :
- skin is wet before peeling.
- use cotton wool or a flannel to do this.
18/10/06
12:05
3
Page 3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Accessim ep5820d0

Tabla de contenido