Removing The Battery - Hilti SID 14-­A Manual De Instrucciones

5.3

Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others. Check that the belt hook is fitted
securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
1. Remove the battery. → page 22
2. Insert the belt hook in the opening provided at the base of the screwdriver's grip.
3. Secure the belt hook with the 2 screws.
5.5 Installing an accessory tool
SID 14­A
SID 22­A
1. Check that the connection end of the accessory tool is clean.
▶ If necessary, clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
4. Before using the power tool, check that the accessory tool is correctly seated and secure.
5.6 Installing an accessory tool
SIW 14­A
SIW 22­A
1. Check that the connection end of the accessory tool is clean.
▶ If necessary, clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Bring the notch in the accessory tool into alignment with the ball on the square drive.
4. Push the accessory tool onto the square drive until it engages.
5. Before using the power tool, check that the accessory tool is correctly seated and secure.
5.7 Installing an accessory tool
SIW 22­A
CAUTION
Risk of injury through use of the wrong type of accessory tool!
▶ Use only accessory tools of the locking type.
▶ Do not use worn or damaged accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Remove the O-ring from the groove in the socket.
3. Pull out the locking pin.
4. Place the socket on the square drive spindle of the tool.
Take care to ensure that the holes in the square drive spindle and socket, into which the locking
ring fits, are in alignment with each other.
5. Insert the locking pin in the socket.
22 English
2
3
4
5
2012667
*2012667*