Descargar Imprimir esta página

Rowenta SUNRAY IR2010F0 Modo De Empleo página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
It is essential to read these instructions carefully and to observe the following recommendations :
A- "Radiant" part
B- Control unit
C- Pull-cord accessory
1-
Selection indicator
2-
Control box fixing screws
3-
Wall-mount fixing holes
4-
Supply cable entry
5-
Supply cable clamp
6-
L and N terminals
7-
Selection pull-cord
8-
Hinge screws and covers
Fig.5: Control unit, front view
Fig.6: Control unit, rear view
IMPORTANT INFORMATION
• This appliance complies with the Community Directives 73/23/EEC and 89/336/EEC.
• This appliance is intended only for domestic use. It may not be used for industrial purposes.
• When in use, this appliance must be kept out of the reach of young children, animals and persons with certain disabilities.
• Do not fit your appliance just above a wall-mounted electricity socket.
• Do not operate your appliance in a dusty atmosphere or where there is a fire risk.
• Before each use, check that the appliance is in good general condition.
• Do not place towels or clothing on the appliance.
• Never insert objects into the appliance (e.g. needles).
• The guarantee is void in the event of damage resulting from improper use.
• Disposal at the end of product life: take your appliance to an appropriate waste collection point.
VERY IMPORTANT
• Do not use your appliance near inflammable objects and materials (curtains, aerosols, solvents etc.).
• Never cover the appliance, even temporarily – it may overheat and be damaged beyond repair.
• Do not touch the appliance with wet hands.
• Never allow water to get into the appliance.
• DO NOT ATTEMPT TO TOUCH THE RADIANT PART DURING OPERATION (this part reaches a high temperature and can cause
severe burns). It is recommended to wait 15 minutes after switching off the appliance before touching it.
• This appliance is only intended for use when fixed to the wall in a horizontal position and correctly oriented
(see chapter "INSTALLATION").
VOLTAGE
Before using it for the first time, check that the supply voltage matches that indicated on the appliance.
This is a class II appliance (double electrical insulation
INSTALLATION
Take the advice of a specialist on the appropriate means of installation.
Your appliance must be oriented as shown in figure 2 (control unit (B) downwards) and must be positioned so as to allow the mini-
mum clearances shown in the same diagram, as well as in accordance with the "Bathroom Installation" safety rules defined in the
paragraph "Bathroom Installation" (fig. 1).
The radiation intensity is relatively high in the vicinity of the appliance, which can raise objects in this area to a high temperature.
You should, therefore, install your radiator with a clearance of 80 cm from any object.
It is strictly FORBIDDEN to fix the appliance to the ceiling or to the wall in a vertical position.
The switches or other control equipment must be beyond the reach of any person using the bath or shower.
BATHROOM INSTALLATION (FIG. 2A)
The IP24 construction of this appliance enables it to be used in any room in the house, including those where there is a risk of water
splashing (kitchen, bathroom etc.).
The electrical installations in the room, the installation of the appliance and its use must, however, be compliant with the regulations
in force in your country.
). It should not be earthed.
GB

Publicidad

loading

Este manual también es adecuado para:

Sunray ir2020f0