Shot Of Steam - Rowenta FOCUS DZ5980U5 Manual De Instrucciones

1103907203 DZ5000_100x150 27/07/10 11:00 Page13
quantity
uto Steam function*
the steam quantity will adjust automatically to the soleplate
temperature.
8 • Shot of steam
(from temperature setting •• upwards)
IMPORT NT Leave an interval of 4 seconds between each
shot and wait until the flow of steam is finished before
standing the iron on its heel.
Press the shot of steam button
steam and remove stubborn creases (fig.14).
9 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment
to avoid burning delicate fabrics.
Hold the iron to the vertical and press the shot of steam button
( fig.15) to remove creases from suits, jackets, skirts, hanging
curtains etc.
IMPORT NT Never direct the steam at persons or animals!
10 • Spray
Press the spray button
11 • nti-Drip system*
It prevents water escaping from the soleplate when the temperature
is too low.
12 • utomatic electronic 3-position cut-out*
If, although switched on, the appliance is not moved, it will
automatically switch off and the auto off light will blink after the
following intervals (fig. 17):
- fter 30 sec., if the iron is left standing on the soleplate or lying
on its side .
- fter 8 mins., if the iron is left standing on its heel.
To switch the iron back on, move the iron gently.
* depending on model
only when the iron is at temperature setting •••.
Set the steam button to
to dampen stubborn creases (fig.16).
to generate a powerful jet of
13
(fig.13) and