KS LEV Manual De Instrucciones página 10

SADDLE INSTALLATION
When the desired seatpost orientation is determined and the
saddle head clamp parts have been aligned with the front of the
bicycle, the saddle can then be installed.
To install the saddle, replace the two saddle head clamp bolts,
spherical nuts, upper and lower floating clamp in the order in
which they were removed.
Before tightening, place the rails of your saddle between the
upper and lower floating clamps so that the rails seat in the
channel provided by the lower floating clamp.
Spherical Nuts Spherical Nuts
Saddle Rails
Upper Floating Clamp
Lower Floating Clamp
Head Clamp Bolts
Head Clamp Bolts
4mm
8 N-m
4mm
8 N-m
See note below See note below
Using a 4mm hex wrench, tighten the two head clamp bolts to the
maximum torque indicated on your KS dropper post head clamp.
Torques may vary by model.
6
8