Toro 117–0448 Instrucciones De Instalación

Trash Bag Kit
GrandStand
Model No. 117–0448
This kit can be installed on either side of the machine.
Installing it on the left side allows for installation of
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Installing the Bracket to a
GrandStand ™
Parts needed for this procedure:
1 Bracket
2 Bolt, (3/8 x 1 inch) (Self tapping)
Procedure
Installing this kit on the left side allows for installation
of the Chute Gate Kit on the right side.
Install the bracket to the side of the machine with 2 bolts
(3/8 x 1 inch) (Figure 1). The bolts are thread forming
bolts. The holes do not require tapping.
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
™ Mowers and Z Master
Description
Bracket
Bolt, (3/8 x 1 inch) (Self tapping)
Bracket
Bolt, (3/8 x 1 inch)
Trash bag
Mower
Register at www.Toro.com.
® G3 Mowers
the Chute Gate Kit on the right side. Two kits can be
installed, one on the left and one on the right.
Qty.
1
Install the bracket to a GrandStand
Mower.
2
1
Install the bracket to a Z Master G3
Mower.
2
1 Install the trash bag.
1. Left side of machine
2. Bracket
Form No. 3361-318 Rev B
Installation Instructions
Use
Figure 1
3. Bolt, (3/8 x 1 inch)
Original Instructions (EN)
Printed in the USA.
All Rights Reserved