Manual Configuration (Without Wps) - THOMSON TG185n Manual Del Usuario

5
5.2

Manual Configuration (Without WPS)

Procedure
Before you can use your THOMSON TG185n as a repeater you have to complete following steps:
1 Switch the THOMSON TG185n to wireless client
2 Assign a static IP address to your
3 Connect the THOMSON TG185n to your access
4 Configure the IP settings of your THOMSON
5 Configure your computer to obtain an IP address
Switch the THOMSON TG185n to wireless client mode
Proceed as follows:
1 On the back panel of your THOMSON TG185n, move the switch to the client position.
2 After a few seconds the Client LED will turn green.
Assign a static IP address to your computer
The IP address must be between 192.168.1.14 and 192.168.1.252. The subnet mask must be 255.255.255.0.
For more information, see
Connect the THOMSON TG185n to your access point
Proceed as follows:
1 Open your web browser and browse to http://192.168.1.12.
2 The THOMSON TG185n Web Interface
3 The THOMSON TG185n lists all the access points that are within range.
4 Select your access point and click Associate.
5 If your access point is secured, the THOMSON TG185n will take you to the Wireless Settings page. Enter
the passphrase/key used by your access point and click Apply.
6 The THOMSON TG185n prompts you that the configuration was successful.
E-DOC-CTC-20080624-0009 v0.2
Your THOMSON TG185n as Wireless Client
computer.
TG185n.
"7.1 Assigning a Static IP to Your Computer" on page
appears. On the Device Status menu, click Site Survey.
mode.
point.
automatically.
44.
33