PAW DN 20 Instrucciones De Montaje página 5

2 Change of the flow line [specialist]
1. Loosen the screw (1).
2. Remove the adapter pieces (2) and (3) for the extension of the plug axis. Take off the
rotary knob (not shown).
3. Loosen the two screws (4) and take off the cover (5).
4. Loosen the screws (6) and pull off the front plate (7).
5. Extract the sealing bush (8) and the valve cock (9) from the mixing valve body.
6. Loosen the screws (10) on the rear side of the mixing valve.
7. Press the cover (11) out of the mixing valve body in the back of the mixing valve.
8. Put the mixing valve cover in again on the other side of the mixing valve body and fix it
by using the screws (10).
9. Insert the sealing bush (8) and the valve cock (9) into the channel of the mixing valve.
Make sure that the o-rings are not damaged.
Only use a lubricant free of mineral oil (see previous page).
10. Fix the front cover (7) by using the screws (6).
11. Turn the cover plate (5) such that the designation PAW (see figure previous page) is on
the bottom and the scale is positioned according to the figure.
12. Fix the cover plate (5) by using the screws (4).
13. Connect the adapter pieces (2) and (3). Connect the rotary knob (not shown).
14. Fix the adapter pieces with the screw (1).
2019/04 9934012-mub-ml – V01 5