Settings: Unit; Control; Control: Speed - Euromate PURE AIR Touch Control Instrucciones Para El Uso

Then the 'PASSWORD' screen appears:
Pressing the box next to 'new' opens a numeric keypad where a 4-digit PIN
can be entered. Remember this code, because without it the Touch Control is
inoperable and can only be reset by Euromate.
8.2

SETTINGS: UNIT

You can set the Touch Control by pressing this icon.
This takes you to the 'DEVICE' screen:
The number of connected DFI's can be entered. The maximum number of
units that can be connected to one Touch Control is 16.
Under 'CONNECTION' you can select how the DFI's should communicate with
the Touch Control. The connection icons are explained in chapter 6.
Pressing the button
'LOCATION' screen:
Here you can select the DFI's you want to locate. Now, when you press the
button,
flash purple for one minute. This allows you to see where the respective DFI
is hanging in the room.
12
opens the
the LED rings of the selected DFI's will
9

CONTROL

The 'HOME' screen also contains the control settings button.
When you press it, the 'CONTROL' screen appears:
9.1

CONTROL: SPEED

Set speed: Here you can set the operating mode (manual or
automatic) and fan speed of the DFI.
PLEASE NOTE!
When a timer event starts, the system will override the set
fan speed.
Here you can choose how you want to set the fan.
When you press this button, the 'MANUAL'
screen appears:
On this screen you can select which units you want to set the speed for.
When you press a number, the button turns green to indicate that the
number has been selected. Now, when you press the 'set speed' button, the
following screen opens:
On this screen you can select the speed at which the fan will run. For
example, if 3000 is selected, the fan will run at the speed required to achieve
an air flow of 3000 m3/h through the filter.