Replace Batteries - Uline H-1101 Instrucciones

12. APW (Average Piece Weight) If the weight of an
individual item is known, you can set that weight in
the scale manually.
• Press the APW key. Use the number keys to enter the
average weight of one piece. Scale switches to
"PCS" and displays the number of pieces
on the scale.
• To clear, press the APW and CLEAR keys at the
same time.
13. TOTAL. Records an accumulated total after a series
of weighings.
• To add the displayed weight to accumulated total.
Press the TOTAL key. Display blinks for 5 seconds.
Press the TOTAL key again before the display stops
blinking to add the total to your accumulated total.
Display shows the accumulated total for 2 seconds
and returns to the previous weighing mode.
• To view the accumulated total. Press and hold the
TOTAL key for 3 seconds. The accumulated total
weight will display until you release the key.
• To clear, press the TOTAL and CLEAR keys at the
same time.
PAGE 2 OF 3
INSTRUCTIONS CONTINUED
14. PEAK HOLD. Memorizes the maximum weight

REPLACE BATTERIES

1.
2. Loosen two 1/4-turn connectors on back of the
3. Pull the cover back. Remove old batteries.
4. Install new batteries. Make sure batteries are
Recharge time for Ni-cad batteries: 16 hours.
Rechargeable battery life: Up to 1,000 cycles.
applied. When in peak mode, the scale will not
display any weight less than the maximum weight.
• To activate, press PEAK HOLD. To turn off, press PEAK
HOLD again. "Peak" indicators on display blink when
scale is in peak mode.
• To clear the peak weight from memory: Press ZERO
or turn off the scale while in peak mode to clear the
peak weight.
Scale operates on 9 alkaline or rechargeable
Ni-cad D-cell batteries.
control box.
+ to + and – to –.
CAUTION! Do not plug in optional charger with
standard D-cell batteries installed. Damage to
batteries and scale can result.
0621 IH-1101