Error Messages - Uline H-1101 Instrucciones

ERROR MESSAGES

-- -- -- Blinking
-------- Not blinking
DISE
LB
OE
EEPE
PAGE 3 OF 3
TROUBLESHOOTING
CAUSES
Scale is in sleep mode
Scale waiting for weight to stabilize
Display error
Scale is unable to display the
number completely
Low battery indicator
Blinks if left too long, scale shuts
itself off
The scale is over capacity or
outside the A/D converter range
EEPROM error
CONTROLS
1-800-295-5510
uline.com
RECOMMENDATIONS
Press any key to change the weight to
resume normal weighing. (Pressing a
key will exit the scale from sleep mode
and perform its normal function.
If no weight is on the scale, press ZERO
to return the weight reading to zero.
Change or recharge batteries.
Reduce load on scale. If OE continues
to display, load cell wiring or circuit
board chip may be bad.
Calibration is corrupted or gone. Scale
requires recalibration.
0621 IH-1101