BDS VW T4 Manual De Instrucciones página 5

REMOVING
1. Disassemble all axle components until the upper joint is fully accessible.
2. Remove the locking ring (B) before applying the tool.
3. Choose suitable adapter (4) or (5) and insert it into puller.
4. Insert reducing fork (6) into the lower part of the puller if necessary. The reducing fork must fit
exactly onto the suspension arm (A).
5. Tighten the puller by operating the spindle (2) and check the puller for a proper alignment.
6. Tighten the spindle (2) with a 24mm wrench or socket with ratchet until the ball joint is
completely pressed out. Caution: The spindle (2) is not suitable for impact wrenches.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed