Environmental Protection - BDS VW T4 Manual De Instrucciones

MOUNTING
1. Clean the ball joint's borehole before the assembly.
2. Insert the adapter (3) into puller (1).
3. Insert reducing fork (7) into lower part of the puller (1), reducing fork must fit exactly onto the
ball joint.
4. Apply ball joint to the suspension arm.
5. Tighten the puller (1) by operating the spindle (2) and check the puller for a proper alignment.
6. Tighten the spindle with a suitable wrench or ratchet until the ball joint fits completely onto the
suspension arm. Important: You must install a new locking ring (B) after the assembly.
Caution: The spindle (2) is not suitable for impact wrenches.

ENVIRONMENTAL PROTECTION

Dispose of this product at the end of its working life environmentally. Recycle unwanted
materials instead of disposing of them as waste. All tools, accessories and packaging
should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment. Contact your local solid waste authority for recycling
information
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed