Assembling The Blower - Shindaiwa EB8510RT Manual Del Usuario

Assembling the Blower (EB8510)
IMPORTANT!
This.unit.is.equipped.with.a.static..
discharge.reduction.wire..This.wire.helps.
direct.static.buildup.into.the.air.stream.
reducing.the.felt.amount.to.the.operator..
1. Place the blower upright on the ground
or a sturdy work surface and note parts
orientation as shown in Figure 4.
. Remove static wire from package and fix
eyelet to right hand engine cover screw.
See Figure 5.
3. Turn the discharge tube out to a right
angle and slip anti-static wire through
the 10mm clamp and flexible tube.
4. Slip the flexible tube over the end of the
90° discharge tube, and secure with the
10mm clamp.
NOTE:
Check to make sure that the 90° discharge
tube swivels freely. If any binding is present,
loosen 10mm clamp and pull wire towards
engine to get more slack and recheck for
free movement.
5. Insert the static wire through the swivel
tube, then install and tighten the 89mm
clamp over the rotating band on the
swivel tube.
6. Slide the handgrip over the swivel tube
and secure with the bolt and wingnut.
7. Fold the end of the static wire back over
the connection of the swivel tube.
See Figure 5.
8. Grasp the nozzle, and push the nozzle
over the swivel tube locking pins
securing the static wire. See Figure 6A.
9. Lock the nozzle to the swivel tube by
rotating the nozzle noting the alignment
marks. See Figure 6B.
6
Anti-Static
Wire 90° Discharge
Tube
102mm
Clamp
Figure 4
Swivel
Tube
Static Wire
Flexible Tube
Static Wire
Connector
Figure 5
IMPORTANT!
Blower.tube.installation.affects.blower.
performance! Make sure the tubes and
nozzle are correctly assembled per above,
and.that.all.connections.are.tight..Blower.
tubes.may.come.apart.during.use.unless.
tubes.are.aligned.and.locked.into.place..
Swivel
Tube
Flexible Tube
Swivel
89mm
Tube
Clamp
Fold Wire
A
Lock Pin
Lock Slot
B
Figure 6
WARNING!
Danger from rotating
impeller!
Stop.the.engine.before.installing.or.
removing the blower tubes! Never
perform.any.maintenance.or.assem-
bly.procedures.on.this.unit.while.the.
engine is running!
Handgrip
Long
Nozzle
(ø74 mm)
Straight
Tube
Short Nozzle
(ø65 mm)
Align the lock pins with the
lock slots, and push the tube
and nozzle together.
Rotate clockwise to lock
making sure the 3 lines
are aligned on both tube
and nozzle.