Before Initial Use; Attaching The Steam Broom; Preparing The Steam Broom; Start-Up - Silvercrest 114903 Instrucciones De Utilización Y De Seguridad

Before Initial Use

Attaching the steam broom

Remove the device from the packaging.
Attach the motor body
(Fig. A).
Tighten both parts together using the retaining
screw and a Phillips screwdriver (Fig. B).
21
ATTENTION! Check the seating of the retain-
ing screw regularly. Otherwise the steam
21
base may detach itself from the device.
9
Press the handle release button
handle until it clicks into place on the motor
15
body (refer to Fig. C and Fig. D).
2

Preparing the steam broom

Unroll the mains cable
lower the pivotable cable winder
this easier.
Pull the release lever of the water tank
upward in the direction shown by the arrow
(Fig. E) and remove the water tank
Turn the water tank
seal (Fig. F).
Fill the water tank
thread with cold tap water (Fig. G). Screw the
seal back on without using too much force.
ATTENTION! In cases of particularly hard
water (with a water hardness of more than
2 mmol / l), use a mixture of 50 % tap water
and 50 % distilled water.
Re-insert the water tank
ensure that the water tank valve is correctly
seated on the filter inlet (Fig H). Then click the
water tank into the appropriate position
11
and check for the correct seating.

Start-up

Note: You can only use the turbo broom
steam function or both functions at the same time.
However, we recommend that you use the two
functions after one another and first use the turbo
114903_silv_Dampfbesen SDB 1500 A1_content_ES_IT_PT.indd 41
to the steam base
2 9
. Lift up the
1
completely. You can
4
to make
14
12
.
11
over and remove the
11
to the lower edge of the
11
into the device and
11
, the
18
Before Initial Use / Start-up
broom to remove dust from the floor. Only
18
activate the steam function thereafter.
Note: There is a groove below the handle into
which you can clamp the mains cable so that it
does not hang in the way during operation.
Switching the turbo
brush on/off
Press the ON/OFF switch
turbo brush (Fig. I). The turbo brush
18
gins to rotate and removes dirt and dust from
the floor, and collects it in the dust collector
ATTENTION! Do not clean the turbo brush
during this process. The steam base
tip over or the dust collector
down. Risk of injury!
Press the ON/OFF button
off the turbo brush .
18

Using the steam function

Only use the device in well-ventilated rooms.
Remove the plug from the socket.
Use the blue pad for soft floors and the
8b
white pad for hard floors. Place the pad
8a
under the steam base
attachment (Fig. J).
19
ATTENTION! Ensure that the water tank is full
to prevent operation without water - otherwise
the pump could burn through.
ATTENTION! Similarly check before use that
all objects and surfaces to be cleaned are heat
resistant and/or compatible. We recommend
that you follow the care instructions of the man-
ufacturer, particularly for treated terracotta and
wooden floors. Conduct a test on an area which
is not easily visible or on a sample piece.
ATTENTION! There is a risk that a white
edge may develop on the floor if the device is
allowed to rest in the same spot for an ex-
tended duration during operation. This edge is
not indicative of damage! You can remove it
to switch on the
5
be-
18
.
6
18
could
9
could fall
6
again to switch
5
8
onto the relevant felt
9
GB/MT 41
09.06.15 08:55