Publicidad
STEP 14
13
Align the Upper Back Panel with the top of the unit. Align the side
edges with the edge of the Upper Left Panel (A) and Upper Right
Panel (B) and nail straight into the back edges as shown.
IMPORTANT! Do not hammer in the nails in the center row until
Lower Back Panel is in place as the back panels will overlap.
Align the Lower Back Panel with the edge of part E. Align the side edges with the edge of Lower Left
Panel (C) and Lower Right Panel (D) and nail straight into the back edges as shown.
systembuild.com
IMPORTANT! THE BACK PANELS ARE A STRUCTURAL PART OF THIS UNIT
AND MUST BE INSTALLED PROPERLY.
Carefully turn the unit over onto its front side as shown. Assure the unit
(x47)
is square. Distance from corner to corner must be equal as shown.
M
1st
13
raw
surface
23
Note: Lower Back Panel
is raw on both sides.
2nd
N
You
Tube
Publicidad
