X-lander X-PULSE Manual Del Usuario página 10

16 I N S TA L L I N G O F B U M P E R B A R
Push in the ends of the bumper bar into mounting holes, until locks are snapped.
17 TA K I N G T H E B U M P E R B A R O F F
Push in the buttons of the bumper bar locks and slide its end out of the mounting holes.
The bumper bar may be tilted, when undone only from single side.
18 B E LT A D J U S T M E N T
To adjust the belt length, move the belt towards a regulator. Regulators are hidden under
protective covers.
19 S H O U L D E R B E LT A D J U S T M E N T
The height of the shoulder belt position may be adjusted based on the child's height. To
change the position, insert the regulator through appropriate holes located in the reclin-
ing seat.
20 AT TAC H I N G T H E C OV E R
To attach the cover, slide the cover bottom part over the footrest and then pull it under the arm-
rest. Fasten the velcro straps together (a) and fasten the snap fasteners to the stroller's frame (b).
21 B U C K L E
To fasten the belt buckle, slide the belt lock into the slot and press it down until it snaps
into place (a). Repeat this procedure for all locks. To unfasten, press the round button until
the moment when the locks are released from the buckle latch (b).
22 M O U N T I N G T H E C A R S E AT
Special adapters are needed in order to mount the baby car seat. Place the adapters in
mounting seats of the frame and attach the car seat by catching it on the adapters.
Attention: Ensure proper fitting of the armchair before using it.
23
R E M OV I N G T H E C A R S E AT
In order to take the car seat off, push in the unlocking pushbuttons on both its sides, while
simultaneously pulling it out of mounting seats. Remove adapters by pushing in the
unlocking pushbutton.
24
M O U N T I N G O F C A R R YC OT
Special adapters are needed in order to mount the carrycot. Place the adapters in mounting
carrycot of the frame and attach the carrycot by catching it on the adapters.
25 D I S M O U N T I N G O F C A R R YC OT
To take the carrycot off, push in the buttons unlocking the catches (a) and pull it out from
mounting seats (b). Remove adapters by pushing in the unlocking pushbutton.
26
L E D L I G H T E N I N G
The LED lightening is placed on the stroller frame, the switch is located on the stroller
frame in the place shown in figure (a). The place for the power batteries is in the bottom
part of the footrest (b). To install the 3x LR 44 batteries, unscrew the bolt shown in figure
and remove the cover. The right battery assembly is presented on the cover. The direction
of battery insertion is shown on the mounting flap.
27 I N F L AT I N G W H E E L S
To inflate the wheel, unscrew the valve pin. Next, put the pump to the valve end and inflate
the wheel. The recommended tire pressure is 1.0-1.5 atm/bar.
28 M O S Q U I TO N E T
The mosquito net is in the pocket under the footrest (a). Place it over the footrest and the
hood (b) and then fasten the straps round the frame bars as shown in Figure (c)
29 AT TAC H I N G X- B AG N U R S E R Y B AG A N D X- M U G H O L D E R
8
X-Mug and X-Bag nursery bag can be attached to the frame using the holders shown in
the picture.