Replace The Tilling Blades - sunjoe 24V-TLR-LTE Manual Del Operador

m
WARNING!
Unexpected blade movement may cause
personal injury. Before servicing, repairing, or inspecting the
unit, turn the motor OFF and remove the battery. Wait for
the blades to completely stop rotating before conducting
inspection, cleaning, or maintenance.
Before and after each use, check the product and accessories
(or attachments) for wear and damage. When necessary,
only use identical replacement parts that are approved by the
manufacturer.
IMPORTANT!
• Wear protective gloves when cleaning or maintaining the
machine.
• Do not use cleaning fluids or solvents or spray the
machine down with water (especially water under
pressure) when cleaning the machine.
NOTE: After each use, follow these steps to properly clean
the unit:
1. Remove soil, dirt, and foliage stuck in the blades, drive
shaft, tool surface, and vents with a brush or dry cloth.
2. Spray or rub biodegradable oil onto the blades.
3. Clean soiled grips with a damp cloth.
Always inspect the machine for damaged and worn parts after
each use. Check that safety features (i.e. labels, guards, etc.)
are in place. Check that nuts, bolts, and screws are tight.

Replace the Tilling Blades

The machine is fitted with two 10 tine steel tilling blades that
can easily be changed. Only use the original replacement part
specified for this tiller + cultivator.
You can purchase replacement blades (Model 24V-TLR-BLD)
and other genuine replacement parts by visiting us online at
sunjoe.com or calling our toll-free customer service helpline
at 1-866-SNOWJOE (1-866-766-9563). The use of parts
that do not meet the original equipment specifications may
lead to improper performance of the tiller + cultivator, may
compromise operator safety and will void the manufacturer's
warranty.
m
WARNING!
The tilling blades are sharp and can
cause severe personal injury if handled incorrectly. Wrap the
blades or wear protective gloves, and use extra caution when
handling.
To replace the blades, follow the steps below:
1. Turn off the unit, remove the battery and wait until the
blades have come to a standstill.
2. Open the ring on the lock pin, then slide the pin out of the
hole on the old blade. Then, remove the old blade from the
motor shaft (Fig. 12).
Fig. 12
Lock pin
Tiller +
cultivator head
3. Insert the new blade onto the motor shaft. Make sure to
align the notches on the blade's hole with the notches on
the motor shaft (Fig. 12). Then, slide the lock pin into the
holes of the blade and motor shaft to keep the blade in
place. Close the ring over shaft to lock the pin. Insert the
battery and resume working (Fig. 13).
Fig. 13
Pin
Ring
Repair
This product does not contain any parts that can be repaired
by the consumer. Contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563)
for assistance.
Storage
• Examine the cordless tiller + cultivator thoroughly for worn,
loose, or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
dealer or call the Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563)
for assistance.
• Remove the battery from the cordless tiller + cultivator
before storing.
13
Steel blade
Blade notch
Motor notch
+
®
+ Sun Joe customer
® ®
+ Sun Joe
®
+ Sun Joe customer service
® ®
®