Jimmy GT306 Manual De Usuario página 7

Use of Garment Steamer
Check before Use
Before use, check whether there is deposit in
the water tank. If there is deposit, please clear
it. Check if the steam hose and the inlet and
outlet are blocked. If there is any blockage,
please clear it.
Affusion of Water Tank
Take out the water tank, unscrew the cover
at the bottom of the tank, add water (in order
to extend the service life of the machine, it is
recommended to use pure water), then tighten
the tank cover and place the tank flat in the
host. (Figure 10, 11)
Connection of Power
Before inserting the plug into the power socket,
please confirm that the voltage is 230V and
keep the power plug and hand dry.
Use of Machine
Hang the clothes with the clothes hanger. After
the machine is connected with power, the power
indicator lights on, step on the foot switch, the steam indicator lights up and the machine starts
to work .(Figure 12)
After use, step on the foot switch to turn off the power, unplug the power supply, place the power
cord around the base.
In the process of use, in order to prevent the steam hose from being in the u-shaped bending
state, please keep the hose in the vertical upward state during use. If you hear the purr or
see the steam is not fluent, please lift the hose in time and keep the hose upright, so that the
condensed water can return to secondary heating to produce steam.
After use, the machine should be cooled for at least 30 minutes. Disassemble the attachments,
turn the host over and pour out the residual water in the machine. Be careful not to scald your
hands. (Figure 13)
Use of Clothes Hanger
When ironing pants, the width of clips can be adjusted according to the width of the pants.
(Figure 14)
10
Water Tank
Water Tank Cover
Water Storage Sink
12
Indicator Light
Power Cord
Foot Switch
14
11
13
Pour the residual water
from the round hole of
the host
5