Philips HR6835/01 Manual De Instrucciones página 10

42
- Add one measuring cap of the cleaning liquid to
the full reservoir (3 litre) (fig. 39).
44
- Place the shampoo reservoir (fig. 40).
- Attach the short shampoo tube to the connector
on the vacuum cleaner. Insert (1) and rotate
anti-clockwise (2) (fig. 41).
- Fix the shampoo trigger to the handgrip of the
46
hose (fig. 42, 43).
- Firmly insert the end of the long shampoo tube
into the connector on the vacuum cleaner
("Click!") (fig. 44).
To release: push the ring towards the appliance
(fig. 45).
- Attach the long
shampoo tube to the
flexible suction hose
and suction tubes
using the clips (fig. 46).
- Place the "Double
Injection" nozzle (fig.
47).
The appliance is now
ready for soft floors
(carpets, rugs).
43
3
45
47
48
49
1
- If you wish your nozzle close to hand (e.g. for
cleaning stairs, upholstery, tapestry) you can
connect the nozzle directy to the hose. Fix the
excess shampoo tube with a clip (fig. 48).
- For hard floors (tiles, ceramic, stone, synthetic)
51
attach the "3-Actions" mopper to the nozzle
(fig. 49). Do not forget to secure the mopper
53
with the clip.
- Pull the mains plug out of the vacuum cleaner
and insert into the wall socket (fig. 50).
- First switch on the pump (fig. 51) and then the
motor (fig. 52).
- Shampoo is applied by squeezing the trigger at
the tube handle (fig. 53).
- Start shampooing as far away from the door as
possible. From that point work your way towards
the door.
On completion of a lane, begin a new lane with
a slight overlap. In this way, the entire area can
be covered strip by strip.
10
50
2
52
54