Bigben TD012SPS Manual De Instrucciones página 21

Phono
Noted:
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest
-
before operating and re-secured again afterwards.
1. Turn on the system until the " POWER LED " light up.
2. Set the speed selector to the proper position depending on the record to be
played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The
platter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift the tone arm from the
record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
REMARK :
As some kind of record the AUTO-STOP area was out of the unit setting, so it will stop before
the last rack finish. in this case, select the AUTO-STOP switch to " OFF " position, then it will
run to the end of the record but will not stop automatically (turn off the unit by POWER button
or switch back the AUTO-STOP switch to " ON " position to stop the platter rotate). Then put
back the tone arm to the rest position.
Speaker Box Connection:
You can connect the system to the provided speaker box at the rear panel of speaker socket
(10).
-
-
Do not discard electrical or electronic devices in the garbage, dispose of
them at your local waste collection point.
Certain elements contained within these devices may be harmful to your
health and the environment.
GB-2