PRECAUTIONS
Do not stand the amplifier vertically on its back.
Always use power source of adequate capacity.
Do not turn on the power of multiple power amplifiers at the same time. Never allow the
ventilation holes on the body of the amplifier to get obstructed in any way.
Input level adjust controls are provided for each channel.
Output can use binding posts, banana posts or 1/4" jacket.
To clean the amplifier, wipe it with a dry cloth. If the case is very dirty, disconnect the AC
cord from the power source, then wipe it witch a cloth dampened in water or mild soap water, then wipe till
dry thoroughly. Never use solvents or chemical cloth, similarly, never spray insecticides as they may cause
discoloration or peeling.
If any trouble is found, disconnect the power cord and contact your dealer.
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
FRONT PANEL:
1. POWER ON/OFF SWITCH:
When turning on the amplifier, the power on/off transient protection starts working. After 3-4
seconds, you can hear a voice "kniak". And 1-2 seconds later, you can hear a voice of "kniak"
once the amplifier has been connected with the speakers.
2. CHA INPUT LEVEL CONTROL
Adjust this control to get the voice you need, when you're far away from the speakers, you can
adjust it with the calibrated markings on the front panel indicating the amount of attenuation
applied to the input signal. This allows proper volume setting applied to the input signal. Also
allows proper volume setting of the speakers when the input signal source is at its rated level.
Use this control when running the amplifier in bridge or parallel mode only.
3. CHB INPUT LEVEL CONTROL
As the same as CHA.
4.5 LEVEL INDICATOR LAMP (RED).
The LEDS will be on in the two situations:
•
When the output signal has reached its clipping level, the LED lights; possibly resulting in
distortion, should this occur, adjust the input control so that the clip LED turns off.
All manuals and user guides at all-guides.com
3