Starting-Up The Unit; Using The Unit - BOMANN MM 5020 CB Instrucciones De Servicio

Máquina para hacer muffins
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
• Keep the appliance and its cord out of reach of children less than
8 years.

Starting-up the unit

Instructions for Use
Before making the first muffins for eating...
Remove any packaging that is still present. Unwind the
mains lead completely.
Clean the housing and the baking surfaces with a damp
cloth.
Non-stick coating
Lightly grease the baking surfaces before the unit is used
for the first time.
Use the appliance for about 10 minutes with the toasting
surfaces closed (see "Using the unit").
Remove the mains plug from the socket and allow the
device to cool down.
Test-bake muffins 2-3 times.
NOTE:
Any smoke or smells produced during this procedure
are normal. Please ensure sufficient ventilation.
Do not eat the muffins prepared during first-time
operation.
After the device has cooled down, wipe the baking surfaces
off with a paper towel.
Electrical connection
1. Check whether the mains voltage that you want to use
matches the one of the device. You will find the information
about this on the type plate.
2. Insert the plug in a duly installed protective contact socket.
The red indicator lamp lights.

Using the unit

NOTE:
Keep the baking surfaces closed while heating.
When the warm up phase has ended, the green control
lamp will light up.
The red control lamp remains on to show that the device
is working.
1. Open the device. Place approx. 1 level tablespoon of mix-
ture into each section of the lower baking surface. Please
ensure that you measure in the quantity of dough correctly,
as excess dough runs over the edges and soils the device.
2. Close the lid.
NOTE:
The green control lamp switches on and off during
baking in order to maintain the baking temperature.
This does not give any indication that the baking
process is finished.
The baking time depends on your individual taste.
The longer the muffins remain in the device, the
greater the degree of browning. Please note the
information contained in the recipe.
3. Open the device after approximately 15 minutes or a few
minutes before the muffins are ready according to the
recipe. Check the result. If the muffins have already turned
brown or risen, they are ready and can be removed.
4. Unfold the lid completely and remove the mains plug from
the socket.
5. Take the muffins carefully out of the pans. Please use a
heat-resistant wooden or plastic spoon. Do not use pointed
or sharp objects to avoid damaging the coating of the bak-
ing surfaces.
6. Lightly grease the baking surfaces again as required after
each baking process.
7. The baking surfaces must always be kept closed during
pauses in the baking.
Switching Off
If you would like to interrupt operation or switch the device off,
remove the plug from the socket. The red control lamp goes off.
Cleaning
WARNING:
Always pull out the plug from the mains socket before
cleaning and wait until the unit has cooled down.
Do not immerse the device in water! It could result in an
electric shock or fire.
CAUTION:
Do not use any wire brush or other abrasive objects.
Do not use any acidic or abrasive detergents.
Baking Surfaces
Remove any food residues while they are still warm with a
damp cloth or paper towel.
Wash off the baking surfaces with a soft sponge and soapy
water; then wipe with clean water and dry thoroughly with
a soft cloth. After drying please apply a thin film of edible oil
to the surface.
25

Publicidad

Tabla de contenido
loading

Tabla de contenido