Metra AX-ADFD02 Instrucciones De Instalación

AX-ADFD02
Ford RSE/SYNC/THX
retention interface 2011-up
The AX-ADFD02 is designed to and must be used with the AX-ADBOX1 or
AX-ADBOX2 (sold seperately). Please refer to AX-ADBOX1 or AX-ADBOX2
for 16-pin connector instructions.
applIcatIons
ford
Fiesta
Focus
Explorer
Interface components
22-pin harness to 24- and 26-pin Ford harness
tools requIred
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
METRA. The World's best kits.
Installation Instructions for AX-ADFD02
2011-up
2012-up
2012-up
™ 1-800-221-0932
Caution
Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air
bag indicator lights must be plugged in before reconnecting the battery
or cycling the ignition.
InstallInG tHe Interface
from the 16-pin harness with stripped leads (included with interface)
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of
the aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of
the aftermarket radio.
Only make the following connections if the vehicle contains the SONY/THX
amplified system.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the purple wire to the radio's right rear positive speaker output.
• Connect the purple/Black wire to the radio's right rear negative speaker output.
from the 22-way harness:
The DIN plug is for future applications.
metraonline.com
(continued on next page)
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION