Metra AX-ADFD02 Instrucciones De Instalación página 2

InstallInG tHe Interface
from the 24-way harness:
• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the Yellow wire to the constant wire of the aftermarket radio.
• Connect the Blue wire to the antenna turn-on of the aftermarket radio.
• Connect the From 3.5 RCA's to the AUX in on the aftermarket radio
(if SYNC is not present).
These wires are to be connected if the vehicle does not have the SONY/THX system
• Connect the Violet wire to the right rear positive wire of the aftermarket radio.
• Connect the Violet/Black wire to the right rear negative wire of the
aftermarket radio.
• Connect the Green wire to the left rear positive wire of the aftermarket radio.
• Connect the Green/Black wire to the left rear negative wire of the
aftermarket radio.
from the 26-Way Harness:
Connect the RSE/SYNC/SAT RCA's to the AUX in on the aftermarket radio
(if retaining SYNC).
12-Way Harness:
This harness is for the ASWC-1-1 (sold separately). Please refer to the ASWC-1
instructions for programming.
AX-ADFD02
(continued)
Installing the aX-adfd02
1. With all the connections completed, plug the 22- and 16-pin harnesses into the
AX-ADFD02.
2. Plug the 24- and 26-pin Ford harness into the vehicle side harness, and plug the
aftermarket radio harness into the aftermarket radio.
3. Reconnect the negative battery terminal.
4. Initialize the interface by cycling the key by turning the ignition on for
30-seconds then back off, and then back on again to test the radio.
audio level adjustment
1. Start your vehicle and turn on the radio having audio playing.
2. Turn your aftermarket radio's volume up 3/4 of the way.
3. With a small screwdriver adjust the potentiometer clockwise to raise the
audio level and counterclockwise to lower the audio level.
4. Once at desired level your audio adjustment is complete.