Waste Disposal - Breville DiamondXpress VIN420X Manual Del Usuario

9. Stand your iron on its heel rest, plug it in to the mains supply socket and switch on.
When the temperature indicator light comes on, iron an old piece of cloth to allow
any remaining water to escape.
10. After use, switch off and unplug your iron from the mains supply and allow it to fully
cool. Empty out any remaining water.
Cleaning the steam holes
To remove any build-up in or around the steam holes which may affect steam
performance, use a cotton wool tip moistened with methylated spirits. Wipe off the
methylated spirits with a damp cloth then dry the soleplate.
Cleaning the exterior of your iron
To clean the exterior of your iron, wipe it with a soft damp cloth and wipe dry.
Auto shut off feature
ALWAYS disconnect your iron from the mains supply socket after use.
NEVER leave the iron unattended with the auto shut off function in operation.
An electronic safety device will automatically switch the heating element off if the iron
has not been moved more than 30 seconds when resting on its soleplate in a horizontal
position. If resting on its heel in a vertical position, this will happen after 15 minutes. The
power light will flash whilst your iron is in auto shut off mode. To restart your iron, gently
move it until the light stops flashing.
Storing
Warning: Allow your iron to completely cool before storing. Always store your iron
on its heel rest. Do not store your iron resting on its soleplate.
The SAFE-STORE™ heat indicator strip
has cooled sufficiently for it to be safe to store. If the strip is red, your iron is too hot.
When the words SAFE-STORE appear on the strip against a solid black background,
the soleplate is at a safe temperature for storing.
Never wrap the power cord around the soleplate. The cord can be neatly wrapped
around the heel of your iron.
After sales service and replacement parts
In the case the appliance does not operate but is under warranty, return the product
to the place it was purchased for a replacement. Please be aware that a valid form of
proof of purchase will be required. For additional support, please contact our Consumer
Service Department at: United Kingdom: 0800 028 7154 | Spain: 0900
81 65 10 | France: 0805 542 055. For all other countries, please
call +44 800 028 7154. International rates may apply. Alternatively,
e-mail: BrevilleEurope@newellco.com.
Troubleshooting
For troubleshooting and FAQs visit www.breville.co.uk/faqs
8
VIN420X_20MLM1.indd 8-9 VIN420X_20MLM1.indd 8-9
shows you when the soleplate of your iron
a
Electrical safety (UK & Ireland only)
This appliance must be earthed.
This appliance is fitted with either a moulded or rewirable BS1363, 13 amp plug. The
fuse should be ASTA approved to BS1362. If the fuse in a moulded plug needs to be
changed, the fuse cover must be refitted. The appliance must not be used without the
fuse cover fitted.
If the plug is unsuitable, it should be
dismantled and removed from the supply
cord and an appropriate plug fitted as
detailed below. If you remove the plug
it must not be connected to a 13 amp
socket and the plug must be disposed of
immediately.
If the plug fuse requires replacement, a
fuse of the same rating as that fitted by
the manufacturer must be used. In order
to prevent a hazard do not fit a fuse of a
lower or higher rating.

Waste disposal

Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist.
E-mail us at BrevilleEurope@newellco.com for further
recycling and WEEE information.
9
9/28/20 09:19 9/28/20 09:19